Ventilation & Airflow

Extractor & Ceiling Fan Installation

Bathroom and kitchen extractor fans and ceiling fans installed across Manchester and Tameside. Correctly zoned for wet areas, ducted properly to the outside, and wired on the right circuit — qualified and fully certified.

Fans We Install

From clearing steam out of a bathroom to keeping a room cool in summer, we fit and replace every type of fan across Manchester and Tameside.

Bathroom Extractor Fans

Clear steam and prevent damp and mould with a correctly-sized fan, ducted to the outside and wired with a timer or humidity sensor.

Kitchen Extractor Fans

Higher-extraction units that cope with cooking heat and grease, ducted properly and wired on the right circuit for the room.

Ceiling Fans

Mounted securely to the joist and balanced for quiet running, with remote or pull-cord control — ideal for warm summer nights.

Fitted Properly

A fan is only as good as the way it is installed. Here is what makes the difference between a fan that works and one that just makes noise.

Ducted to the Outside

Every extractor fan is ducted to an external wall or roof terminal — never left venting into the loft, where it causes condensation and rot.

Safely Zoned & Certified

Bathrooms are special locations under BS 7671. We install to the correct zones, notify the work under Part P, and issue certification.

Timers & Humidity Sensors

Run-on timers and humidity-controlled switching clear moisture automatically and keep bathrooms and kitchens free of damp.

The Right Fan for the Room

We size the fan to the room’s extraction needs so it genuinely clears the air — quietly, without constant noise or wobble.

Frequently Asked Questions

Yes. Building Regulations (Part F) require bathroom and wet-room extraction to be ducted to the outside — not just into the loft or ceiling void, which dumps moist air into the roof and causes damp and rot. We always run the duct to an external wall or roof terminal.

For anything beyond a straight like-for-like swap, yes. Bathrooms are “special locations” under the wiring regulations (BS 7671), with strict zones governing where electrical equipment can go, and a new fan circuit is notifiable under Part P. A qualified electrician makes sure it is safely zoned, correctly wired, and certified.

Yes. We can wire extractor fans with a run-on timer (the fan keeps running for a few minutes after you leave the room) or a humidity sensor (it switches on automatically when moisture rises). Both are excellent for clearing steam and preventing damp and mould.

Often, yes — but a ceiling fan is much heavier than a light fitting and must be fixed securely to a joist or a proper fan-rated mounting box, not just an existing ceiling rose. We check the fixing and the wiring and install it so it runs quietly without wobble.

Usually, yes. The common causes are a blocked or disconnected duct, an underpowered fan for the size of the room, or a wiring or control fault. We will diagnose it and either repair it or replace it with the right unit for the space.

Areas We Cover

We provide extractor & ceiling fan installation across Denton, Tameside, Stockport and the wider Greater Manchester area — find your local team below.

Need a Fan Fitted or Replaced?

Whether it is a steamy bathroom, a kitchen that needs better extraction, or a ceiling fan for the summer, Steels Electrical will fit it properly and certify the work. Get a free, no-obligation quote today.

Call Now Get a Quote